Standard Features:
- High performance, low noise scroll compressors to match the required total load.
- Resiliently factory-mounted on rubber grommets for vibration isolation
- Refrigeration circuit includes both high and low pressure safety switches
- Unit is factory charged with environmentally friendly Low GWP R32 refrigerant.
- Two single-stage scroll compressor for partial load applications.
- Compressor location outside the condenser section to avoid air bypass.
- Internal overload protection included with compressor.
- Indoor fan motors are direct drive EEM motors as standard to provide easy adjustment for airflow control.
- Slide out forward curb fan for easy maintenance and replacement
- High-static drive options for application with high airflow/static requirements
- Each fan assembly is dynamically trim balanced at the factory before shipment for quick start-up and efficient operation
- Ball bearing Direct-Drive EEM motor removes the need for belts, sheaves, bearings and lubrication
- Motor equipped with thermal overload to provide protection and lasting operation.
- All units use large face area outdoor coils. These coils are constructed with seamless copper tubes, mechanically bonded into aluminum plate-type fins with full drawn collars to completely cover the tubes for high operating efficiencies. The indoor coil section is installed in a draw through configuration to provide better dehumidification.
- Coils are factory pressure tested to ensure pressure and leak integrity
- Copper tube / aluminum fin coils on evaporator
- All units use large face area outdoor coils
- Microchannel heat exchanger technology on all condenser coils for improved performance and reduced refrigerant load
- ETL certified heating modules provide a custom match to specific design requirement.
- Wrinkle Bend Technology available on all Daikin gas heat exchangers. The Wrinkle Bend Technology reduces the manufacturing stress that leads to defects and pinholes in the tubes at the same time as it increases the gas turbulence to amplify the heat transfer.
- All single phase 5 ton Gas units have 81% AFUE.
- All 3-Phase models have a minimum 81% T.E. (Thermal Efficiency)
- The furnace has a tubular design with in-shot gas burner manifold and is installed downstream of the supply fan.
- The module contains an induced draft fan that will maintain a negative pressure in the heat exchanger tubes for the removal of the flue gases to protect indoor air quality.
- Each burner module provides flame roll-out safety protection switches and a high temperature limit switch for reliable operation.
- Induced draft fan includes an airflow safety switch to prevent heating operation in the event of no airflow for occupant safety.
- All burner assemblies are factory tested and adjusted prior to shipment.
- Heating control is fully integrated into the unit’s control system for quick start-up and reliable control.
- Units are factory-wired with color-coded wires and complete 24-volt Electromechanical controls package.
- Units include single-point power entry as standard.
- Terminal strips are provided as standard for easy installation and low voltage power wiring
- Unit provides a draw-through filter section as standard for better air quality and long lasting component maintenance. Filters installed on the units are standard off the shelf sizes for easy replacement.
- Easy accessibility using our tool-less filter access.
- Unit is fully insulated to prevent sweating and thermal losses, using our foil face fiberglass insulation which also omits exposed filter fibers into the airstream.
- 1 inch Raised flanges around the supply and return
- The full perimeter base rail is built using heavy gauge galvanized steel for a stronger structural installation, the base rails are a minimum of 3.5 inches tall and include holes to allow for overhead rigging and lifting with forklifts.
- Electrical lines and can be brought through the base of the unit or through the horizontal knockout for easy installation and accessibility on the field.
